Trendnet 18-1106-33 User Manual

Note: The following short instructions are intended as a guide to 

users who are fully familiar with safety procedures and 
operating instructions described earlier in this manual.

1. 

Check to make sure that all tubings are firmly connected and 
secured with hose clamps.

2. 

Check the liquid level and fill the bath if needed (the level 
should be 2-4 cm below the lid).

3. 

Switch the power on at the mains switch.

4. 

Set the safety temperature limit using the dial on the rear 
of the unit. 

5. 

Set the setting range limit of the circulator (if required by the 
application or any safety precautions). 

6. 

Set the working temperature. Press           to select the S mode

.

Use          or           to set the working temperature. Confirm with

before the display automatically returns to the actual     

working temperature.

7. 

Set the temperature correction value if required.

Printed in Sweden by 

TK i Uppsala, July 1997

A