Pelco C3408M Leaflet

The IPS-MINIADPT adapter cable is required to use the IPS-RMK or IPS-CABLE with the Spectra 

®

 Mini 

dome for on-site setup and testing of the dome and for uploading revised operating software and language 
files. 

1.  Remove the trim ring and dome bubble from the Spectra Mini dome by prying down on the trim 

ring at one of the Pelco logos. 

2.  Plug the six-pin connector on the adapter cable into the mating connector on the dome. 

3.  Plug the RJ-45 connector on the adapter cable into the mating connector on the IPS-CABLE 

(either the IPS-CABLE by itself or the IPS-CABLE that is part of the IPS-RMK remote monitor kit). 

4.  Follow the instructions in the installation/operation manual that is supplied with the IPS- CABLE 

or IPS-RMK. 

5.  When you are finished, remove the adapter cable and reinstall the trim ring and dome bubble. 

TO SPECTRA 

TO IPS-CABLE 

MINI DOME 

Figure 1.  IPS-MINIADPT Cable 

Worldwide Headquarters • 3500 Pelco Way • Clovis, California 93612 USA • www.pelco.com

USA & Canada • Tel: 800/289-9100 • Fax: 800/289-9150

International • Tel: 1-559/292-1981 • Fax: 1-559/348-1120

Pelco, the Pelco logo, Camclosure, Esprit, Genex, Legacy, and Spectra are registered trademarks of Pelco. 

©Copyright 2005, Pelco. All rights reserved.

Endura and ExSite are trademarks of Pelco.
DLP is a registered trademark of Texas Instruments, Inc.