Network Technologies ASI-IP-GTW User Manual
ASI-IP-GTW User's Manual
Page
38
3.5.6 Security
Figure 11 shows the sub-page for user security (password protection).
Figure 15. Time setting sub-page
Enable Password Protection: Mark this to enable password protection.
If password is not set, it will use the factory default password.
If password is not set, it will use the factory default password.
Factory default:
Administrator login: admin
Password:
Administrator login: admin
Password:
salvador
Old Password: To be able to set a new password, the user must know
the old password.
New Password: Type the new password. Allowed length is 0 to 20
characters.
characters.
Retype New Password: Retype the new password as a security
measure.
measure.
Change Password: Click this button to activate the new password.
Note: If you forget the password that has been configured, you will
need to log on to the unit through the RS232 port. When you are logged
on, type “userdb factory_defaults”. This will reset the password to the
factory defaults detailed above.
need to log on to the unit through the RS232 port. When you are logged
on, type “userdb factory_defaults”. This will reset the password to the
factory defaults detailed above.