NEC NDA-24233 User Manual
NDA-24233 Issue 2
Page 3-27
VisuaLink 128/384 Engineering Guide
Console Command List
SINC
Setting Incoming Call Mode
5-8
Description:
Sets the incoming call mode. There are three ways to receive an incoming
call: manual incoming call mode, automatic incoming call mode, and
selective incoming call mode. In a manual incoming call mode, an
operation to receive a call is required. In an automatic incoming call mode,
a communication starts when a request for an incoming call is received. In
a selective incoming call mode, only those calls that are registered are
received. All others are rejected.
call: manual incoming call mode, automatic incoming call mode, and
selective incoming call mode. In a manual incoming call mode, an
operation to receive a call is required. In an automatic incoming call mode,
a communication starts when a request for an incoming call is received. In
a selective incoming call mode, only those calls that are registered are
received. All others are rejected.
Command Format:
SINC p1
p1:
M
:
manual incoming call mode
A
:
automatic incoming call mode
S
:
selective incoming call mode
Note 1: When p1 is omitted, the current setting status is displayed in a
normal response.
Note 2: When p1 = S, an incoming call from the dial number other than
those ISDN numbers registered as speed dial numbers.
Response:
Normal Response: If p1 is set:
OK
If p1 is omitted:
p1 OK
p1 OK
p1:
M
:
manual incoming call mode
A
:
automatic incoming call mode
S
:
selective incoming call mode
Error Response: