Nortel Networks NN44200-300 User Manual
Supported peripheral devices
21
The Nortel server subnet and ELAN subnet must be properly configured
for correct CallPilot operation. To ensure correct configuration, Nortel
recommends that you consult a network specialist.
for correct CallPilot operation. To ensure correct configuration, Nortel
recommends that you consult a network specialist.
Remote access connectivity
The RS-232 COM1 connector on the rear of the 1002rp server provides
the connection to an external modem. The modem allows administrators
and technical support personnel to administer the 1002rp server from a
remote location.
the connection to an external modem. The modem allows administrators
and technical support personnel to administer the 1002rp server from a
remote location.
pcAnywhere is used to establish the remote access connection to the server.
Supported peripheral devices
Introduction
This section identifies external devices that are supported by the 1002rp
server.
server.
Device
Description
Modem
A 56-Kbit/s external modem (NTRH9078) provides remote access
to the 1002rp server. The modem connects to the RS-232 COM1
connector on the rear of the server.
to the 1002rp server. The modem connects to the RS-232 COM1
connector on the rear of the server.
Since the modem is an external device, it requires its own AC power
source referenced to the same ground as the 1002rp server and the
switch to which it is connected.
source referenced to the same ground as the 1002rp server and the
switch to which it is connected.
Ethernet hub or switch
A 10Base-T Ethernet hub or switch provides the ELAN subnet
connection between the 1002rp server and the Meridian 1 switch
or Communication Server 1000 system. The customer can
supply an ethernet hub or switch from third-party vendors or from
Nortel.
connection between the 1002rp server and the Meridian 1 switch
or Communication Server 1000 system. The customer can
supply an ethernet hub or switch from third-party vendors or from
Nortel.
Since the ethernet hub or switch is an external device, it requires
an AC power source.
an AC power source.
ATTENTION
To comply with EMC radiation requirements, a Class A hub
must be located 10 m (33 ft) away from the 1002rp server.
Shielded Ethernet cables must be used.
must be located 10 m (33 ft) away from the 1002rp server.
Shielded Ethernet cables must be used.
Nortel CallPilot
1002rp Server Hardware Installation
NN44200-300
01.01
Standard
5.0
23 February 2007
Copyright © 2007, Nortel Networks
Nortel Networks Confidential
.