Nxp Semiconductors ISP1183 User Manual

 

The procedure to install hardware, firmware, INF and driver is as follows: 

1.  Switch off the peripheral PC. 

2.  Remove all unnecessary cards on the peripheral PC. 

3.  Plug the ISP1183 eval board in the ISA slot of the peripheral PC. 

4.  Switch on the peripheral PC. 

5.  On the peripheral PC, under the DOS mode, run firmware 1183FW.EXE. 

If it is the first time that the eval board is connected to the host PC, the host OS Device 
Manager will prompt for the installation of INF and drivers. 

6.  Select the location of D13TEST.INF and D13TEST.SYS from the ISP1183 evaluation 

diskette and complete the installation procedure. 

Test applet D13TEST.EXE exercises all the ISP1183 endpoints as shown in 

. 

 

 shows a description of endpoints operation on the ISP1183 eval board. 

 

UM10044_4 

© NXP B.V. 2007. All rights reserved.