Nortel Networks 2750 User Manual
Appendix A Technical specifications 89
Nortel VPN Router Installation — VPN Router 2750
56/64K CSU/DSU WAN interface card
The 56/64K CSU/DSU WAN interface card has a single RJ-48 connector that
provides the signals needed to interface to network equipment.
provides the signals needed to interface to network equipment.
shows the 56/64K CSU/DSU WAN interface card.
Figure 36
56/64K CSU/DSU WAN interface card
The connector on the 56/64K CSU/DSU WAN interface card accommodates an
8-pin RJ-48 modular patch cord.
8-pin RJ-48 modular patch cord.
Use cable that is wired in accordance with ANSI T1.410 wiring style. This wiring
style ensures that a twisted pair inside the patch cord carries the transmit signal
(pins 1 and 2) and the receive signal (pins 7 and 8). Nortel strongly recommends
that you use professionally manufactured patch cords.
style ensures that a twisted pair inside the patch cord carries the transmit signal
(pins 1 and 2) and the receive signal (pins 7 and 8). Nortel strongly recommends
that you use professionally manufactured patch cords.
You connect the 56/64K CSU/DSU WAN interface card to the service provider
network using a straight-through cable or a crossover cable, depending on how the
service provider wired its jack.
network using a straight-through cable or a crossover cable, depending on how the
service provider wired its jack.
Note: Nortel does not supply an interface cable with the
56/64K CSU/DSU WAN interface card.
56/64K
DDS