Nortel Networks NN43001-318 User Manual
20
Installing ISDN BRI hardware
Procedure 2
Remove the module cover for card installation
Step
Action
To remove the covers from the modules with unused card slots, follow the
procedure below. Refer to
procedure below. Refer to
1
Use a flat-blade screwdriver to unlock the left latch on the front of the
cover by turning the screw 1/4 turn clockwise.
cover by turning the screw 1/4 turn clockwise.
2
Use a flat-blade screwdriver to unlock the right latch on the front of
the cover by turning the screw 1/4 turn counterclockwise.
the cover by turning the screw 1/4 turn counterclockwise.
3
While holding the cover so it does not fall off, slide the latches toward
the center of the cover.
the center of the cover.
4
Pull the cover toward you and lift it away from the module.
5
Place the cover in a safe place away from the working area to avoid
damaging it.
damaging it.
6
Repeat steps 1 through 5 for each cover requiring removal.
—End—
Figure 4
Module cover locking latches
Module cover locking latches
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318
01.02
Standard
Release 5.0
20 June 2007
Copyright © 2003-2007, Nortel Networks
.