Nortel Networks NN43001-318 User Manual
Installing ISDN BRI hardware for trunk applications
41
Procedure 12
Connecting clock reference cables
Step
Action
1
Search for available D-sub 9 connector slots on the I/O panels of the
selected IPE and CE I/O modules (if the I/O panel is equipped with
D-sub 9 connector slots). If none is available, look for an empty slot
used for 25-pair wire connectors (the cables contain two adapter
plates to convert a 25-wire slot to two D-sub 9 connector slots).
selected IPE and CE I/O modules (if the I/O panel is equipped with
D-sub 9 connector slots). If none is available, look for an empty slot
used for 25-pair wire connectors (the cables contain two adapter
plates to convert a 25-wire slot to two D-sub 9 connector slots).
2
Connect the cables as shown in
; if choosing IPE slots 0, 4, 8, or 12, remove
the transmit and receive cable installed on pins 72 - 79 and secure
them to a proper place.
them to a proper place.
—End—
Figure 11
Clock reference cable connection
Clock reference cable connection
Clock recovery
The SILC is configured in the slave-slave mode when acting as a trunk
interface. This is configured through the Maintenance Signaling Channel
(MSC). The microcontroller configures the S/T chips on the SILC as
appropriate.
interface. This is configured through the Maintenance Signaling Channel
(MSC). The microcontroller configures the S/T chips on the SILC as
appropriate.
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318
01.02
Standard
Release 5.0
20 June 2007
Copyright © 2003-2007, Nortel Networks
.