Nortel Networks BSG12ew User Manual
38
Installation options
NN47928-302
NN47928-302
4
Open the cable management door.
5
Use two of the supplied screws to attach the wall-mount bracket to the wall
through the cable trough.
through the cable trough.
6
Use three of the supplied screws to attach the upper portion of the wall-mount
bracket to the wall as shown in the following figure. Leave approximately 0.5 cm
(0.25 in.) of the screw exposed.
bracket to the wall as shown in the following figure. Leave approximately 0.5 cm
(0.25 in.) of the screw exposed.
7
Align the holes of the wall-mount bracket over the screws.
8
Slide the bracket down onto the screws.
9
Tighten the wood screws against the wall-mount bracket.
10
Insert the power supply retention clip into the BSG8ew.
2
2
2
1
1
1
Cable Management Door
Note
: Nortel recommends you install the screws
in the three holes labeled 1 or the three holes
labeled 2.
labeled 2.
2
2
2
1
1
1