Nortel Networks R2MFC User Manual
24 Chapter 2 Overview
NN40010-300
RS232 port
There is an RJ-45 serial port connector named RS232 on the faceplate of the R2MFC MBM. The
N0026100 cable, shipped with the R2MFC MBM, is used to connect a computer to the RS232 port
for advanced configuration or for CLI-based diagnostics of the R2MFC MBM.
N0026100 cable, shipped with the R2MFC MBM, is used to connect a computer to the RS232 port
for advanced configuration or for CLI-based diagnostics of the R2MFC MBM.
shows the pinout information to make a new N0026100 cable.
E1 Status LEDs
The R2MFC MBM has four visual status monitor indicators in the middle section of the faceplate.
They are:
They are:
•
ERR Tx — indicates a Transmit error on the E1
•
ERR Rx — indicates a Receive error on the E1
•
ALM Tx — indicates a Transmit alarm on the E1
•
ALM Rx — indicates a Receive alarm on the E1
Bantam jacks
The R2MFC MBM contains Bantam Jacks in the middle of the faceplate, to be used for connecting
diagnostic equipment. The jacks are labeled DIAG.
diagnostic equipment. The jacks are labeled DIAG.
BNC and RJ-48 connectors
The R2MFC MBM has both BNC and RJ-48 external E1 connectors located on the far right of the
faceplate. These connectors are used to connect the R2MFC MBM to the Central Office (CO).
faceplate. These connectors are used to connect the R2MFC MBM to the Central Office (CO).
The default interface will be based on the country code selected. Mexico is the factory default. See
for the country code
default settings.
R2MFC MBM back and underside elements
The back and underside of the R2MFC MBM contain the following elements:
•
•