Nortel Networks 201i User Manual

November 2006

Preparing peripheral devices

201i Server Hardware Installation

127

Set the CD-ROM drive DIP switches as described in the following table:

If you are also installing a tape drive, set the tape drive SCSI ID (see page 
128); otherwise, set the CD-ROM drive device termination (see page 130). 

1

Parity

ON

2

Termination

Note: For more information about daisy 
chaining SCSI devices, see “Setting SCSI 
device termination” on page 130.

If the CD-ROM drive is the first and only 
device, set this switch to ON.

If the CD-ROM drive is the first device 
and daisy chained with the tape drive, set 
this switch to OFF.

3

Test

OFF (for factory use only)

4

Block

OFF

5

Eject

OFF

Note: If this switch is set to ON, the eject 
button on the CD-ROM drive is disabled. 
To eject the CD-ROM from the drive, a 
software eject command must be sent over 
the SCSI bus.