Nortel Networks 201i User Manual
November 2006
Connecting peripheral devices to the 201i server
201i Server Hardware Installation
153
Connecting the 201i server to the switch,
ELAN, and CLAN
ELAN, and CLAN
Introduction
The CLAN and ELAN connections are established by using the 201i server
multi I/O cable.
multi I/O cable.
To establish the switch and network connections
1 Do one of the following:
ATTENTION
For important considerations about using the Embedded
LAN (ELAN) in your network, see “About the ELAN”
in the CallPilot Installation and Configuration Task List.
LAN (ELAN) in your network, see “About the ELAN”
in the CallPilot Installation and Configuration Task List.
IF you are installing the
201i server in a
201i server in a
THEN
large Meridian 1
(for example,
Option 51C)
(for example,
Option 51C)
ensure that the 50-pin amphenol connector
on the multi I/O cable (NTRH0912) is
connected to the newly installed backplane
cable (NTRH3501) on the I/O panel at the
rear of the switch.
on the multi I/O cable (NTRH0912) is
connected to the newly installed backplane
cable (NTRH3501) on the I/O panel at the
rear of the switch.
Option 11C
connect the 50-pin amphenol connector on
the multi I/O cable (NTRH0912) to the
high-density connector associated with the
left slot occupied by the 201i server.
the multi I/O cable (NTRH0912) to the
high-density connector associated with the
left slot occupied by the 201i server.