Nortel Networks M3820 User Manual

84

Digital Telephone IP Adapter Installation and Administration Guide

Configuring the IP Adapter unit using the telephone menu

 Standard 2.1

To complete initial configuration of the Digital Telephone IP Adapter unit, you 
must use the telephone menu. After initial configuration, you can use 
Configuration Manager for changes, administration, and firmware upgrades. For 
a more detailed description of Configuration Manager, refer to the Reach Line 
Card Installation and Administration Guide (NTP 555-8421-210).

Note: You cannot access the telephone menu and Configuration Manager at the 
same time. You must use one or the other. If you want to use Configuration 
Manager to configure the Digital Telephone IP Adapter unit, refer to Chapter 5, 
“Changing configuration settings using Configuration Manager”.

Before you start configuring the Digital Telephone IP Adapter unit, have the 
following information available:

!

the unit ID for the Digital Telephone IP Adapter unit

!

the online and offline SPRE codes

!

the registration and deregistration SPRE codes

!

an IP address, including subnet mask and the IP address of the IP Gateway, 
if applicable

The network administrator can provide the above information to the end-user by 
filling out and delivering the Telephone Menu - Configuration Values form in 
Appendix A, “Planning forms.”