Nortel Networks 4050 User Manual
Chapter 3 Managing the network access devices 75
Nortel Secure Network Access Switch 4050 User Guide
Adding a network access device using the CLI
You can add a network access device to the configuration in two ways. You must
repeat the steps for each switch that you want to add to the domain configuration.
repeat the steps for each switch that you want to add to the domain configuration.
•
•
Using the quick switch setup wizard
To add a network access device to the Nortel SNAS 4050 domain using the quick
switch setup wizard, use the following command:
switch setup wizard, use the following command:
/cfg/domain 1/quick
You can later modify all settings created by the quick switch setup wizard (see
).
1
Launch the quick switch setup wizard.
2
Specify the type of switch. Valid options are:
•
ERS8300
(for an Ethernet Routing Switch 8300)
•
ERS5500
or
ERS55
(for an Ethernet Routing Switch 5510, 5520, or
5530).
The default is
ERS8300
.
Note: The input is case sensitive.
3
Specify the IP address of the network access device.
>> Main# cfg/domain 1/quick
Enter the type of the switch (ERS8300/ERS5500) [ERS8300]
IP address of Switch: <IPaddr>