Nortel Networks 4050 User Manual
790 Chapter 17 Configuration example
320818-A
2
Assign the VLAN port members.
Since the edge switches in this example are operating in Layer 2 mode, enable
802.1q tagging on the uplink ports to enable them to participate in multiple
VLANs, then add the ports to the applicable VLANs.
802.1q tagging on the uplink ports to enable them to participate in multiple
VLANs, then add the ports to the applicable VLANs.
3
Create IP interfaces for the VLANs.
4
Since the edge switches are operating in Layer 2 mode, configure DHCP relay
agents for the Red, Yellow, Green, and VoIP VLANs.
agents for the Red, Yellow, Green, and VoIP VLANs.
Use the applicable show commands on the router to verify that DHCP relay
has been activated to reach the correct scope for each VLAN.
has been activated to reach the correct scope for each VLAN.
Configure the Ethernet Routing Switch 8300 using the CLI
The configuration procedure is based on the following assumptions:
•
You are starting with an installed switch that is not currently configured as
part of the network.
part of the network.
•
You have installed Software Release 2.2.8.
•
You have configured basic switch connectivity.
•
You have initialized the switch and it is ready to accept configuration.
•
You have configured devices as described to this point.
Steps
To configure the Ethernet Routing Switch 8300 for the Nortel SNA network,
perform the following steps:
perform the following steps:
1
2
3
4
5
6