Epson C823301 User Manual

After you have set the DIP switches, install the fax board in

your printer following the instructions in your printer manual.

See the section on installing an optional interface board.

After you have installed the board, connect the phone cable

included with the board to the connector labeled LINE on the

board. Plug the other end into a standard modular-type

telephone connector (jack). If you wish, you can also plug a

telephone into the connector labeled PHONE.

Manual Reception

to Phone Line to Telephone

Serial Interface

Button

After you have installed the fax board in your printer, perform

a self test by following the steps below:

1. While holding down the manual reception button on the

fax board, turn on the printer.

2. Release the manual reception button when the printer’s

FEED indicator starts blinking.

The printer then prints a two-page self test. This shows that the

board is properly installed and gives you information about the

board and its settings.

setup 

7