Lantronix 10 User Manual

Firmware 

UDS-10 User Guide 

4-1 

You can update the unit's internal operational code to a newer revision, or change the code to 
operate with a specific vendor.   

The UDS-10-IAP was designed to allow loading of vendor specific protocol firmware. This 
firmware takes the place of the IAP Standard Tunnel Protocol. Vendor specific protocols and 
the software tools needed to load them can be found on the software CD.   

You can obtain the most up-to-date protocol firmware and release notes for the unit from the 
Lantronix Web site (

www.lantronix.com

) or by using anonymous FTP (

ftp.lantronix.com

). 

Once you load a vendor specific protocol, you must reference the user manual associated with 
that protocol, since many of the setup and configuration dialogs will be changed. Some 
features, such as web pages, may not be available with certain vendor protocols.  
Note: If you change the protocol to a vendor specific protocol, you MUST reference the 
associated protocol manual for setup and configuration information. The menu options 
shown in this manual are for Standard Tunnel Protocol.  

There are several ways to update the unit's internal operational code (*.ROM): via 
DeviceInstaller (the preferred way), via TFTP, via another unit, or via the serial port. You can 
also update the unit's internal Web interface (*.COB) via TFTP or DeviceInstaller. 

The firmware files are located on the software CD in the firmware folder. Here is a list of 
typical names for those files. Check the Lantronix web site for the latest versions and release 
notes. 

AD - DF1 
MultiMaster 

DF1 Multi-master ad0100.rom
(IAP only) 

NA 

AM - Modbus 
Bridge 

AM0144.rom 
(IAP only) 

NA 

AQ - Standard  Standard Tunnel aq0100.rom 

(IAP only) 

(Standard Tunnel_aq0100wb6.cob) 
(or cbxw300.cob) 

UDS10 ltx45.rom 

cbxw300.cob