Delta Electronics DVPAEXT01-H Leaflet
Warning
Read this instruction sheet carefully before using DVPAEXT01-H.
DVPAEXT01-H is an OPEN TYPE device and therefore should be installed in an enclosure free of airborne dust,
humidity, electric shock and vibration. The enclosure should prevent non-maintenance staff from operating the
device (e.g. key or specific tools are required to open the enclosure) in case danger and damage on the device may
occur.
device (e.g. key or specific tools are required to open the enclosure) in case danger and damage on the device may
occur.
DVPAEXT01-H (including DVPAEXT1L-H and DVPAEXT1R-H) is used for connecting MPU and extension unit or
among extension units. Use DVPACAB4A09/DVPACAB4A18 to extend the transmission distance between
DVPAEXT1L-H and DVPAEXT1R-H.
DVPAEXT1L-H and DVPAEXT1R-H.
Make sure the power of the MPU and extension unit is switched off when wiring and power on MPU and the
extension unit after the installation of DVPAEXT01-H is completed.
extension unit after the installation of DVPAEXT01-H is completed.
Introduction
Thank you for choosing Delta's DVP series accessory. DVPAEXT01-H is a connector for the extension cable
of extension units. The maximum extension distance available is 1.8m. DVPAEXT01-H is only applicable for
the connection between DVP-EH/EH2/PM series MPU and DI/DO, AI/AO extension units and does not
occupy any extension point or module space.
Product Profile & Outline
DVPAEXT1L-H in the left side (prior level)
DVPAEXT1R-H in the right side (next level)
1
3
4
3
5
5
2
6
6
1
3
4
6
6
3
3
Unit: mm
1
Upper cover of connection port
4
DIN rail
2
Terminal for extension cable
5
Extension cable
3
DIN rail clip
6
Direct fixing hole
ENGLISH
Specifications
DVPAEXT01-H
Model
Item
DVPAEXT1L-H
DVPAEXT1R-H
Power supply
Supplied by MPU through its internal bus: 5V DC (4.5 VDC ~ 5.5 VDC) (-10% ~ 10%)
Power consumption
0.5W
0.5W
Noise immunity
ESD: 8KV Air Discharge
EFT: Power Line: 2KV
RS: 26MHz ~ 1GHz, 10V/m
EFT: Power Line: 2KV
RS: 26MHz ~ 1GHz, 10V/m
Operation/storage
Operation: 0°C ~ 55°C (temperature), 50 ~ 95% (humidity), pollution degree 2
Storage: -25°C ~ 70°C (temperature), 5 ~ 95% (humidity)
Storage: -25°C ~ 70°C (temperature), 5 ~ 95% (humidity)
Shock/vibration
immunity
immunity
International standard: IEC61131-2, IEC 68-2-6 (TEST Fc)/IEC61131-2 & IEC
68-2-27 (TEST Ea)
68-2-27 (TEST Ea)
Weigh (g)
100
100
Installation and Wiring
Connect DVPAEXT01-H with modules
Using DVPAEXT01-H to connect DVP-EH/EH2/PM series MPU with DI/DI, AI/AO extension units.
Cable Connection
When installing DVPAEXT1L-H and DVPAEXT1R-H, please use DVPACAB4A09/DVPACAB4A18
connection cable.
connection cable.
25
14
13
1
1
13
14
25
TO DVPAEXT1L-H
25 PIN D-SUB
TO DVPAEXT1R-H
25 PIN D-SUB
25 PIN D-SUB female
DVPAEXT1L-H COM Port
25
1
1
25
25 PIN D-SUB f emale
D VPAEXT1R-H COM Port
.
.
.
Note:
The DVPAEXT01-H package does not contain the connection cables mentioned above. Please purchase the
cables from our distributors.
注意事項
請在使用之前,詳細閱讀本使用說明書。
本機為開放型(OPEN TYPE)機殼,因此使用者使用本機時,必須將之安裝於具防塵、防潮及免於電擊
/
衝擊意外之外殼配線箱內。另必須具備保護措施(如:特殊之工具或鑰匙才可打開)防止非維護人員操作
或意外衝擊本體,造成危險及損壞。
或意外衝擊本體,造成危險及損壞。
本產品 DVPAEXT01-H(內含 DVPAEXT1L-H 與 DVPAEXT1R-H)用於主機與擴充機之間或擴充機與擴充
機連接延長之用。DVPAEXT1L-H 與 DVPAEXT1R-H 之間可以連接線(DVPACAB4A09/DVPACAB4A18)
來延長傳輸距離。
來延長傳輸距離。
配線時請務必關閉主機與擴充機電源,安裝完成後,才可上電。
產品簡介
謝謝您採用台達 DVP 配件。本機為擴充機延長線連接器,有效延伸距離最大為 1.8 公尺。僅適用於
DVP-EH/EH2/PM
DVP-EH/EH2/PM
系列主機與 DI/DO、AI/AO 擴充機間之連線,且不佔用擴充點點數及擴充模組台數。
產品外觀及各部介紹
DVPAEXT1L-H
為左側(前級)
DVPAEXT1R-H
為右側(後級)
1
3
4
3
5
5
2
6
6
1
3
4
6
6
3
3
尺寸單位:mm
1
連接器連接口上蓋
4
DIN
軌固定槽
2
延長線端口
5
擴充排線
3
DIN
軌固定扣
6
直接固定孔
繁體中文