Emerson CC1000DM User Manual
S E T U P
Operational Checks
2-10
2
Po w e r R e q ui re m en t s
Be sure your power supply is sufficient for the board. The combined power (3.3 volts
and 5 volts) for a CC1000dm is 27 watts.
and 5 volts) for a CC1000dm is 27 watts.
for the CC1000dm. Please contact Artesyn Technical Support at 1http://www.arte-
syncp.com/support on the internet or send E-mail to support@artesyncp.com if you
have specific questions regarding the board’s power requirements.
syncp.com/support on the internet or send E-mail to support@artesyncp.com if you
have specific questions regarding the board’s power requirements.
E nv i ro n me nt a l C o ns i d er a t i o ns
As with any printed circuit board, be sure that air flow to the board is adequate. Chassis
constraints and other factors greatly affect the air flow rate. The environmental require-
ments are as follows:.
constraints and other factors greatly affect the air flow rate. The environmental require-
ments are as follows:.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
O P E R A T I O N A L C H E C K S
All products are tested before they are shipped from the factory. When you receive your
CC1000dm, follow these steps to assure yourself that the system is operational:
CC1000dm, follow these steps to assure yourself that the system is operational:
1
Visually inspect the board for components that could have loosened during shipment.
2
Verify that the front panel is secure.
3
By default, the CC1000dm carrier card is configured to support 3.3 V I/O operation on the
secondary bus. Please be sure to select the appropriate voltage for your application.
Voltage:
Range:
Typical Current
(amps):
(amps):
Usage:
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
+3.3 V
+5/-3%
1.0
Board logic
+5 V
+5/-3%
0.4
Board logic
+12 V
±5%
0.5
PMC slot power
–12 V
±5%
0.5
PMC slot power
VIO
±5%
0.75
PCI signaling for board logic
Voltage:
Usage:
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operating Temperature
0 to +55
O
Centigrade, ambient (at board)
Relative Humidity
Not to exceed 95% (non-condensing)
Storage Temperature
-40 to +85
O
Centigrade, ambient
Shock and Vibration
NEBS Level 3 compliant
Table 2-5:
Power Requirements
Table 2-6:
Environmental Requirements