VIVOTEK PZ6122 User Manual

 

 

 
 

 
 
 

www.vivotek.com 

T: 886-2-82455282 

F: 886-2-82455532 

 
 

Please verify that your product package 
contains all the accessories listed in the 
foregoing Package Contents.  Depending on 
the user’s application, an Ethernet cable may 
be needed. The Ethernet cable should meet the 
specs of UTP Category 5 and not exceed 100 
meters in length. 

Connect the power adapter jack to the 

Network Camera before plugging in to the 
power socket. This will reduce the risk of 
accidental electric shock. 

 
Upon powering up, the device runs through a self-test procedure and the front LEDs 
will blink between green and red for a few times. If self-test passes, the LEDs will shut 
off and the Network Camera will be on stand-by and ready for software installation. If 
self-test fails the red LED will blink several times. Refer to Appendix A for 
troubleshooting. 
 
 

Make sure the Ethernet is firmly connected to a switch hub. After attaching the 
Ethernet cable plug in the power adapter. If the LED turns out to be steady green after 
self-test, go to next paragraph “Software Installation”.