Westell Technologies 327W User Manual
030-300500 Rev. A
87
October 2006
User Guide
VersaLink™ Gateway (Model 327W)
WAN PORT
Factory Default = DSLATM PORT
Possible Responses:
DSLATM PORT
ETHERNET PORT 1
Possible Responses:
DSLATM PORT
ETHERNET PORT 1
Status
Allows you to enable or disable your VC (Virtual Connection)
VPI
Displays the VPI (Virtual Path Indicator) value for a particular VC, which is
defined by your Service Provider.
defined by your Service Provider.
VCI
Displays the VCI (Virtual Channel Indicator) value for a particular VC,
which is defined by your Service Provider.
which is defined by your Service Provider.
Protocol
NOTE: The configuration
specified by your Service
Provider will determine which
Protocols are available to you.
NOTE: The configuration
specified by your Service
Provider will determine which
Protocols are available to you.
Displays the Protocol for each VC, which is specified by your Service
Provider.
Possible Response:
PPPoA = Point to Point Protocol over ATM (Asynchronous Transfer Mode)
PPPoE = Point to Point Protocol over Ethernet
Bridge = Bridge Protocol
Classical IPoA = Internet Protocol over ATM (Asynchronous Transfer
Mode). This is an ATM encapsulation of the IP protocol.
Provider.
Possible Response:
PPPoA = Point to Point Protocol over ATM (Asynchronous Transfer Mode)
PPPoE = Point to Point Protocol over Ethernet
Bridge = Bridge Protocol
Classical IPoA = Internet Protocol over ATM (Asynchronous Transfer
Mode). This is an ATM encapsulation of the IP protocol.
Bridge Broadcast
Factory Default = CHECKED
When this setting is CHECKED, VersaLink will allow Broadcast IP packets
to/from the WAN.
When this setting is NOT CHECKED, VersaLink will block Broadcast IP
packets to/from the WAN.
This setting is only valid if one of the Virtual Channels is configured for
Bridge mode.
When this setting is CHECKED, VersaLink will allow Broadcast IP packets
to/from the WAN.
When this setting is NOT CHECKED, VersaLink will block Broadcast IP
packets to/from the WAN.
This setting is only valid if one of the Virtual Channels is configured for
Bridge mode.
Bridge Multicast
Factory Default = CHECKED
When this setting is CHECKED, VersaLink will allow Multicast IP packets
to/from the WAN.
When this setting is NOT CHECKED, VersaLink will block Multicast IP
packets to/from the WAN.
This setting is only valid if one of the Virtual Channels is configured for
Bridge mode.
When this setting is CHECKED, VersaLink will allow Multicast IP packets
to/from the WAN.
When this setting is NOT CHECKED, VersaLink will block Multicast IP
packets to/from the WAN.
This setting is only valid if one of the Virtual Channels is configured for
Bridge mode.
Spanning Tree Protocol
Factory Default = DISABLED
Spanning Tree Protocol is a link management protocol that provides path
redundancy while preventing undesirable loops in the network. For Ethernet
network to function properly, only one active path can exist between two
stations.
When ENABLED, two bridges are used to interconnect the same two
computer network segments. Spanning Tree Protocol will allow the bridges to
exchange information so that only one of them will handle a given message
that is being sent between two computers within the network.
NOTE: Spanning Tree can’t be enabled if VLAN is enabled.
Spanning Tree Protocol is a link management protocol that provides path
redundancy while preventing undesirable loops in the network. For Ethernet
network to function properly, only one active path can exist between two
stations.
When ENABLED, two bridges are used to interconnect the same two
computer network segments. Spanning Tree Protocol will allow the bridges to
exchange information so that only one of them will handle a given message
that is being sent between two computers within the network.
NOTE: Spanning Tree can’t be enabled if VLAN is enabled.