Raritan Computer EMX2-111 User Manual
Chapter 10: Using the Command Line Interface
235
Setting the Networking Mode
If your EMX device is implemented with both of the wired and wireless
networking mechanisms, you must determine which mechanism is
enabled for network connectivity before further configuring networking
parameters.
networking mechanisms, you must determine which mechanism is
enabled for network connectivity before further configuring networking
parameters.
This command syntax enables the wired or wireless networking mode.
config:#
network mode <mode>
Variables:
<mode> is one of the modes: wired or wireless.
Mode
Description
wired
Enables the wired networking mode.
wireless
Enables the wireless networking mode.
Note: If you enable the wireless networking mode, and the EMX does not
detect any wireless USB LAN adapter or the connected wireless USB
LAN adapter is not supported, the message "Supported Wireless device
not found" is displayed.
detect any wireless USB LAN adapter or the connected wireless USB
LAN adapter is not supported, the message "Supported Wireless device
not found" is displayed.
Example
The following command enables the wired networking mode.
config:#
network mode wired
Configuring IP Protocol Settings
By default, only the IPv4 protocol is enabled. You can enable both the
IPv4 and IPv6 protocols, or only the IPv6 protocol for your EMX device.
IPv4 and IPv6 protocols, or only the IPv6 protocol for your EMX device.
An IP protocol configuration command begins with network ip.