RAD Data comm E1 User Manual
Quick Start Guide
FOM-E1/T1 Installation and Operation Manual
2 Operating
FOM-E1/T1
Connecting the Cables
To connect cables:
1. Connect the E1/T1 electrical interface.
2. Connect the fiber optic interface.
3. Connect the power cable (first to the modem, then to the mains).
1. Connect the E1/T1 electrical interface.
2. Connect the fiber optic interface.
3. Connect the power cable (first to the modem, then to the mains).
Operation starts when the power is applied to the rear panel power
connector.
connector.
2. Operating
FOM-E1/T1
1. Check that the TEST switch is set to the NORM position.
2. Verify LED status. All the LED indicators should be OFF, except for the PWR
2. Verify LED status. All the LED indicators should be OFF, except for the PWR
indicator.
3. If there is an indication of a malfunction or fault, run a diagnostic test.