Promise Technology J610s User Manual

VTrak J610s, J310s Product Manual

16

Populate the VTrak with 3.5-inch SAS or SATA disk drives.

Install all of the drive carriers into the VTrak enclosure to ensure proper airflow, 
even if you do not populate all the carriers with disk drives.  

1.

Remove the front bezel (J310s only).

2.

Remove a disk drive carrier.

3.

Optional. The AAMUX adapter is recommended for SATA disk drives used 
with VTraks with two I/O modules, so that both modules can access a SATA 
disk drive.
Place the optional AAMUX into the disk drive carrier and attach it with the 
four screws.
•

Install only the screws supplied with the AAMUX.

•

The AAMUX fits into the carrier with the SAS connector at the back. See 
Figure 10.

•

Snug each screw. Be careful not to over tighten.

4.

Carefully lay the drive into the drive carrier at the front, so that the screw 
holes on the bottom line up.

Use only the counter-sink screws supplied with the VTrak. Use of 
other types of screws can damage the enclosure or the adjacent 
drives.

W

ARNING:

C

ount

er-sink scr

ews only

.

Disk Drive Mounting Holes

without AAMUX

Disk Drive Mounting Holes

with AAMUX

AAMUX

Mounting Holes