Promise Technology J610s User Manual
53
Appendix A: Second I/O Module
The VTrak J610s and J310s units ship with one or two I/O modules. If your VTrak
came with only one I/O module, you can upgrade by installing a second I/O
module. The following instructions describe how to install a second I/O module.
came with only one I/O module, you can upgrade by installing a second I/O
module. The following instructions describe how to install a second I/O module.
To install a second I/O module into a VTrak J610s or J310s unit:
1.
1.
Power down the VTrak.
2.
Press the release button on the dummy I/O module, pull the handle down
and remove the dummy I/O module from the enclosure.
and remove the dummy I/O module from the enclosure.
3.
Slide the new I/O module into the slot.
4.
Gently push the new I/O module all the way into the slot until the handle
locks.
locks.
5.
Connect your data cables to the new I/O module.
See page 20 for more information.
See page 20 for more information.
6.
Optional. Connect your serial cable to the second I/O module.
See page 27 for more information.
See page 27 for more information.
7.
Power up the VTrak.
To verify proper installation and function, run the enclosure command in the CLI.
Because the new I/O module is installed in the right slot, it will automatically take
the Standby role in the CLI screen. See page 36 for more information.
Because the new I/O module is installed in the right slot, it will automatically take
the Standby role in the CLI screen. See page 36 for more information.