Grandstream Networks GXW-410xv User Manual

 

Administrator password.  Only the administrator can configure the “Advanced Settings” 
page.  Password field is purposely left blank for security reasons.  The maximum 
password length is 25 characters. 

G723 encoding rate (6.3kbps or  5.3kbps) 

This field defines the layer 3 QoS parameter which can be the value used for IP 
Precedence or Diff-Serv or MPLS. Default value is 48. 

This contains the value used for layer 2 VLAN tag. Default setting is 
blank. 

Default is 4 seconds.   

Local RTP port  This parameter defines the local RTP-RTCP port pair the GXW-410xv will listen and 

transmit. It is the base RTP port for channel 0. When configured, channel 0 will use this 
port _value for RTP and the port_value+1 for its RTCP; channel 1 will use port_value+2 
for RTP and port_value+3 for its RTCP. The default value is 5004. 

This parameter, when set to Yes, will force random generation of both the local SIP and 
RTP ports. This is usually necessary when multiple GXW-410xvs are behind the same 
NAT.  

This parameter specifies how often the GXW-410xv sends a blank UDP packet to the 
SIP server in order to keep the “hole” on the NAT open. Default is 20 seconds. 

NAT IP address used in SIP/SDP message. Default is blank. 

IP address or Domain name of the STUN server. 

This radio button will enable GXW-410xv to download firmware or configuration file 
through either TFTP or HTTP. 

This is the IP address of the configured TFTP server. If selected and it is non-zero or 
not blank, the GXW410x will attempt to retrieve new configuration file or new code 
image from the specified TFTP server at boot time. It will make up to 5 attempts before 
timeout and then it will start the boot process using the existing code image in the Flash 
memory. If a TFTP server is configured and a new code image is retrieved, the new 
downloaded image will be verified and then saved into the Flash memory. 
 
Note: Please do NOT interrupt the TFTP upgrade process (especially the power supply) 
as this will damage the device.  Depending on the network environment this process 
can take up to 15 or 20 minutes. 

The URL for the HTTP server used for firmware upgrade and configuration via HTTP.   
For example, ttp://provisioning.mycompany.com:6688/Grandstream/1.0.0.36 
Here “:6688” is the specific TCP port that the HTTP server is listening at, it can be 
omitted if using default port 80. 
 
Note: If Auto Upgrade is set to No, GXW-410xv will only do HTTP download once at 
boot up. 

Grandstream Networks, Inc. 

GXW-410xv User’s Manual 

Page 14 of 30