RATOC Systems CB31U User Manual

2. Setup

2

When you use Windows 95, go to Chapter 2-1.

When you use Windows 98, go to Chapter 2-2.

When you use Windows Me, go to Chapter 2-3.

When you use Windows 2000, go to Chapter 2-4.

When you use Windows Xp, go to Chapter 2-5.

     • At least one SCSI device must supply termination power to the SCSI bus. Read the SCSI device

        manual if you are not sure whether the SCSI device provides termination power. But, there is an exception.

        You can connect Iomega Zip drive to the CB31U, though the Zip drive can not provide termination

      power.

     • You can not boot up system from a SCSI device connected to the CB31U. Do not install Operating

        System into a SCSI device connected to the CB31U because you can not boot up system from it.

     • You can not format a HDD, Jaz, Zip drive connected to the CB31U with FDISK command. And you

        can not use software using DISK-BIOS(INT 13h). If you want to format and create partition, use our

        SCSI utility. Refer to Chapter 4.

     • Do not enable virtual memory setting for a HDD, Jaz, Zip drive connected to the CB31U.

     • The CB31U does not support DOS mode of Windows 98/95.

    • The total length of cabling on the SCSI bus should not exceed 5ft(1.5m).

    • It is not recommended that you connect more than two SCSI devices in daisy-chain.

      • If your PC has only one PC card slot which is connected to a floppy disk drive, you have to copy the

       files in the floppy disk supplied from us onto your HDD before you set up the CB31U.

    • Do not turn off your SCSI device connected to the CB31U when you have the PC in suspend(resume).

       If you want to have the PC in suspend mode, remove the CB31U from the PC.