RATOC Systems CB31U User Manual

MS-DOS

56

5. How to install Windows 95/98

This section gives you information on how to make a startup flopply disk on your own when the

MKDISK.EXE does not work. With the startup floppy disk, you can access to the SCSI CD-ROM drive

connected to the CB31U and install Windows 95 from the SCSI CD-ROM drive connected to the CB31U.

Follow the steps through to make a Windows 95 startup floppy disk

   1.Edit Config.sys file in a Windows 95 startup floppy disk

     Edit config.sys file in a Windows 95 startup floppy disk as shown below.(This is an example)

     DEVICE = HIMEM.SYS

     DEVICE = EMM386.EXE  X = CC00-CFFF

     BUFFERS = 10

     FILES = 20

     DEVICE = CBENABLE.EXE  IRQ = A  MEM = CC00

     DEVICE = ASPCB3x.SYS  /V

     DEVICE = REXCD.SYS  /D:MSCD001 /E

 NOTE:

CBENABLE.EXE  is CardBus Enabler. Refer to CBENABLE.EXE parameter.

ASPCB3x.SYS  is ASPI Manager. Refer to ASPCB3x.SYS parameter.

REXCD.SYS  is CD-ROM driver. Refer to REXCD.SYS parameter.

2.Make Autoexec.bat file in the Windows 95 startup floppy disk and edit it as shown below.

        @echo off

        MSCDEX.EXE  /D:MSCD001

3. a.Copy the CBENABLE.EXE, ASPCB3x.SYS, REXCD.SYS in the [Dos] folder in the CB31U

  floppy disk for Windows98/95 to the Windows 95 startup floppy disk.

    b.Copy the EMM386.EXE and MSCDEX.EXE in your system to the Windows 95 startup floppy disk.

4.Insert the Windows95 startup floppy disk and start your PC.

   The SCSI CD-ROM will be assigned and you can access to the SCSI CD-ROM drive. You can install

  Windows 95 from the SCSI CD-ROM drives.