Minicom Advanced Systems IP Control User Manual
USER GUIDE
14
17. Administration > Serial Settings
Where you have a Serial device connected to the system you must configure the
RS232 settings.
RS232 settings.
To do so:
From the menu click Serial Settings, the Serial Settings appear, see Figure 9.
Figure 9 Serial Settings
Type a device name and choose the correct device parameters. Note! Where you
have a Minicom Serial Remote Power Switch connected, see below Assign to
RPS.
have a Minicom Serial Remote Power Switch connected, see below Assign to
RPS.
17.1 Show
Tick Show to make the Serial device appear in the list of servers/devices that can
be accessed.
be accessed.
17.2 Assign to RPS
Where a Minicom Serial Remote Power Switch (RPS) is connected to the Serial
port, tick this box. All other parameters are then grayed out. See the RPS
Installation Guide for further information on installing and operating the RPS.
port, tick this box. All other parameters are then grayed out. See the RPS
Installation Guide for further information on installing and operating the RPS.
18. Security > Settings
Configure the security features, such as Account Blocking, Password Policy and
Idle Timeout, as explained below.
Idle Timeout, as explained below.
From the Security section click Settings, the Security Settings appear, see Figure
10.
10.