Intelligent Motion Systems MForce Series Microstepping PowerDrive User Manual
1-11
Part 1: Hardware Specifications
Options and Accessories
Parameter Setup Cable and Adapters
The optional 12.0' (3.6m) parameter setup cable part number MD-CC300-000 facilitates communications
wiring and is recommended with first order. It connects from the 10-Pin IDC Connector located at P2 to a
PC's USB port. If the12-pin pluggable locking wire crimp connector is used at P1, adapter MD-ADP-1723C
is required to use the MD-CC300-000.
wiring and is recommended with first order. It connects from the 10-Pin IDC Connector located at P2 to a
PC's USB port. If the12-pin pluggable locking wire crimp connector is used at P1, adapter MD-ADP-1723C
is required to use the MD-CC300-000.
USB to SPI ..........................................................................................................MD-CC300-000
Prototype Development Cable
To speed prototype development, these cables connect to user interface via flying leads with MForce mating
connector on opposite end.
connector on opposite end.
Mating connector to 12-pin pluggable locking wire crimp plugs into MForce or adapter MD-ADP-1723C.
Choose from 2 lengths:
Choose from 2 lengths:
12.0" (30.5cm) ..........................................................................................................ADP-3512-FL
10.0' (3.0m) .......................................................................................................... PD12-1434-FL3
10.0' (3.0m) .......................................................................................................... PD12-1434-FL3
Mating connector to MForce 4-pin motor interface:
10.0' (3.0m). ....................................................................................................... PD04-MF17-FL3