ZyXEL Communications P-661H Series User Manual
Chapter 2 Introducing the Web Configurator
P-661H/HW Series User’s Guide
42
2.3 Resetting the ZyXEL Device
If you forget your password or cannot access the web configurator, you will need to use the
RESET button at the back of the ZyXEL Device to reload the factory-default configuration
file. This means that you will lose all configurations that you had previously and the password
will be reset to “1234”.
RESET button at the back of the ZyXEL Device to reload the factory-default configuration
file. This means that you will lose all configurations that you had previously and the password
will be reset to “1234”.
2.3.1 Using the Reset Button
1 Make sure the POWER LED is on (not blinking).
2 Press the RESET button for ten seconds or until the POWER LED begins to blink and
2 Press the RESET button for ten seconds or until the POWER LED begins to blink and
then release it. When the POWER LED begins to blink, the defaults have been restored
and the ZyXEL Device restarts.
and the ZyXEL Device restarts.
2.4 Navigating the Web Configurator
We use the P-661H-D1 web screens in this guide as an example. Screens vary slightly for
different ZyXEL Device models.
different ZyXEL Device models.
2.4.1 Navigation Panel
After you enter the admin password, use the sub-menus on the navigation panel to configure
ZyXEL Device features. The following table describes the sub-menus.
ZyXEL Device features. The following table describes the sub-menus.
Figure 9 Web Configurator: Main Screen
Use
submenus to
configure
ZyXEL Device
features.
Click the Logout icon at any time
to exit the web configurator.