ZyXEL Communications P-2602H User Manual

 Chapter 3 Internet and Wireless Setup Wizard

P-2602H(W)(L)-DxA User’s Guide

3 Configure your wireless settings in this screen. Click Next.

Figure 26   Wireless LAN 

The following table describes the labels in this screen.

"

The wireless stations and ZyXEL Device must use the same SSID, channel ID 
and WEP encryption key (if WEP is enabled), WPA-PSK (if WPA-PSK is 
enabled) for wireless communication.

4 This screen varies depending on the security mode you selected in the previous screen. 

Fill in the field (if available) and click Next.

Table 11   Wireless LAN Setup Wizard 2

Network 

Name(SSID)

Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless 

LAN. 
If you change this field on the ZyXEL Device, make sure all wireless stations use the 

same SSID in order to access the network. 

Channel 

Selection

The range of radio frequencies used by IEEE 802.11b/g wireless devices is called a 

channel. Select a channel ID that is not already in use by a neighboring device.

Security

Select Automatically assign a WPA key (only available if you enable OTIST) if 

you want OTIST to configure a WPA key for you.
Select Manually assign a WPA-PSK key to configure a Pre-Shared Key (WPA-PSK). 

Choose this option only if your wireless clients support WPA. See 

 for more information.

Select Manually assign a WEP key to configure a WEP Key. See 

 for more information.

Select Disable wireless security to have no wireless LAN security configured and 

your network is accessible to any wireless networking device that is within range.

Back

Click Back to display the previous screen.

Next

Click Next to proceed to the next screen. 

Exit

Click Exit to close the wizard screen without saving.