ZyXEL Communications P-661HW User Manual

P-661H/HW Series User’s Guide

62

Chapter 3 Wizards

The following table describes the fields in this screen.

These screens let you enter the rest of the Internet settings, which depend on the encapsulation 
your Internet connection uses (and the mode you selected, for RFC1483).

This screen appears if your Internet connection uses Ethernet encapsulation.

Figure 22   Internet Setup Wizard: ISP Parameters (Ethernet)

Table 11   Internet Setup Wizard: ISP Parameters

Mode

Select Routing (default) if your ISP allows multiple computers to share an Internet 

account. Otherwise, select Bridge.

Encapsulation

Select the encapsulation type your ISP uses from the Encapsulation drop-down list 

box. Choices vary depending on what you select in the Mode field. 
If you select Bridge in the Mode field, select either PPPoA or RFC 1483. 
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP or 

PPPoE.

Multiplexing

Select the multiplexing method used by your ISP from the Multiplex drop-down list 

box either VC-based or LLC-based. 

Virtual Circuit 

ID

VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit. 

Refer to the appendix for more information.

VPI

Enter the VPI assigned to you. This field may already be configured.

VCI

Enter the VCI assigned to you. This field may already be configured.

Back

Click Back to go back to the previous screen.

Next

Click Next to continue to the next wizard screen. The next wizard screen you see 

depends on what mode and encapsulation you selected above.

Exit

Click Exit to close the wizard screen without saving your changes.