ZyXEL Communications P-660 User Manual
P-660 Series Support Notes
Connect the LAN ports of all computers and the P-660 to a HUB using a straight
Ethernet cable.
Ethernet cable.
2. TCP/IP configuration
Since the P-660 is set to DHCP server as default, so you need only to configure the
workstations as the DHCP clients in the networking settings. In this case, the IP
address of the computer is assigned by the P-660. The P-660 can also provide the
DNS to the clients via DHCP if it is available. For this setup in Windows, we check
the option 'Obtain an IP address automatically' in its TCP/IP setup. Please see the
example shown below.
workstations as the DHCP clients in the networking settings. In this case, the IP
address of the computer is assigned by the P-660. The P-660 can also provide the
DNS to the clients via DHCP if it is available. For this setup in Windows, we check
the option 'Obtain an IP address automatically' in its TCP/IP setup. Please see the
example shown below.
Set up your P-660
The following procedure shows you how to configure your P-660 as Router mode for
routing traffic. We will use SMT menu to guide you through the related menu. You
can use console or Telnet for finishing these configurations.
routing traffic. We will use SMT menu to guide you through the related menu. You
can use console or Telnet for finishing these configurations.
1. Configure P-660 as router mode in Menu 1 General Setup.
Menu 1– General Setup
System Name= P-660
Location=
19
All contents copyright © 2005 ZyXEL Communications Corporation.