ZyXEL Communications P-660HW-DX User Manual

Chapter 15 Remote Management Configuration

P-660HW-Dx User’s Guide

Figure 113   Remote Management: Telnet

The following table describes the labels in this screen.

Use the following steps to Telnet into your ZyXEL Device’s command interpreter. See 

 for more about the commands.

1 If your computer is connected to the ZyXEL Device over the Internet, skip to the next 

step. Make sure your computer IP address and the ZyXEL Device IP address are on the 
same subnet. 

2 In Windows, click Start (usually in the bottom left corner) and Run. Then type 

telnet 

and the ZyXEL Device’s IP address. For example, enter 

telnet 192.168.167.1

 (the 

default IP address).

3 Click OK. A login screen displays. Enter the password at the prompts.

"

The default password is 1234. The password is case-sensitive.

Table 83   Remote Management: Telnet

Port

You may change the server port number for a service if needed, however you must 

use the same port number in order to use that service for remote management.

Access Status

Select the interface(s) through which a computer may access the ZyXEL Device 

using this service.

Secured Client 

IP

A secured client is a “trusted” computer that is allowed to communicate with the 

ZyXEL Device using this service. 
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify to 

access the ZyXEL Device using this service.

Apply

Click Apply to save your customized settings and exit this screen. 

Cancel

Click Cancel to begin configuring this screen afresh.