ZyXEL Communications P-870HW-I User Manual

P-870HW-I1 User’s Guide

Appendix F Log Descriptions

411

Go to the command interpreter interface. 

1 Use the sys logs load command to load the log setting buffer that allows you to configure 

which logs the ZyXEL Device is to record. 

2 Use sys logs category to view a list of the log categories.

Figure 270   Displaying Log Categories Example

3 Use sys logs category followed by a log category to display the parameters that are 

available for the category.

Figure 271   Displaying Log Parameters Example

4 Use sys logs category followed by a log category and a parameter to decide what to 

record.

Use 0 to not record logs for that category, 1 to record only logs for that 
category, 2 to record only alerts for that category, and 3 to record both 
logs and alerts for that category. Not every parameter is available with 
every category.

5 Step 5.Use the sys logs save command to store the settings in the ZyXEL Device (you 

must do this in order to record logs).

• Use the sys logs display command to show all of the logs in the ZyXEL Device’s log.
• Use the sys logs category display command to show the log settings for all of the log 

categories.

Copyright (c) 1994 - 2004 ZyXEL Communications Corp.
ras>?
Valid commands are:
sys             exit            ether           aux
ip              ipsec           bridge          bm
certificates    cnm             8021x           radius
ras>

ras> sys logs category access
Usage: [0:none/1:log/2:alert/3:both] [0:don't show debug type/
1:show debug type]