ZyXEL Communications wireless n300 range extendor User Manual

 Chapter 6 Wireless LAN

WRE2205 User’s Guide

Note: WPS times out after two minutes of pressing a button. Press the button on the 

second device within about a minute of the first, then wait two minutes for the WPS 

configuration to complete.

To add the second wireless station, you have to press these buttons on both device and the wireless 
station again after the first 2 minutes.

Figure 33   Network > Wireless LAN > WPS Station

The following table describes the labels in this screen.

Use this screen to choose an access point that you want the WRE2205 to connect to. You should 
know the security settings of the target AP.

To open this screen, click Network > Wireless LAN > AP Select tab.

Table 17   Network > Wireless LAN > WPS Station

Config Mode

Use this to select Registrar or Enrollee mode. Select Registrar mode to make wireless 
clients follow the wireless settings of the WRE2205. Select Enrollee mode to make the 
WRE2205 follow the wireless settings of an access point.

Push Button

Use this button when you use the PBC (Push Button Configuration) method to configure 
wireless stations’s wireless settings. See 

.

Click this to start WPS-aware wireless station scanning and the wireless security 
information synchronization. 

Input station’s 
PIN number

Use this button when you use the PIN Configuration method to configure wireless station’s 
wireless settings. See 

Type the same PIN number generated in the wireless station’s utility. Then click Start to 
associate to each other and perform the wireless security information synchronization.