ZyXEL Communications ZYWALL10 User Manual
ZyWALL 10 Internet Security Gateway
Firmware and Configuration File Maintenance
10-5
Figure 10-8 Telnet into Menu 24.6 Restore Configuration
10.4 Upload Firmware
Menu 24.7 -- System Maintenance - Upload Firmware allows you to upgrade the firmware and the
configuration file via the console port. There are two components in the system: the router firmware and the
configuration file, as shown below.
configuration file via the console port. There are two components in the system: the router firmware and the
configuration file, as shown below.
Figure 10-9 Menu 24.7 — System Maintenance — Upload Firmware
10.4.1 Uploading the Router Firmware
Menu 24.7.1 shows you the instructions for uploading the router firmware. Follow the procedure below to
upload the file:
upload the file:
Step 1.
Enter
y
at the prompt to go into debug mode.
Step 2.
Enter
atur
after the
Enter Debug Mode
message.
Step 3.
Wait for the
Starting XMODEM upload
message before activating Xmodem upload on
your terminal.
Menu 24.7 - System Maintenance - Upload Firmware
1. Upload Router Firmware
2. Upload Router Configuration File
2. Upload Router Configuration File
Enter Menu Selection Number:
Menu 24.6 – Restore Configuration
To transfer the firmware and the configuration file, follow the procedure
below:
below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your router. Then type "root" and
2. Type "open" and the IP address of your router. Then type "root" and
SMT password as requested.
3. Type “put backupfilename rom-0” where backupfilename is the name of
your backup configuration file on your workstation and rom-spt is the
remote file name on the router. This restores the configuration to your
router.
4. The system reboots automatically after a successful file transfer.
3. Type “put backupfilename rom-0” where backupfilename is the name of
your backup configuration file on your workstation and rom-spt is the
remote file name on the router. This restores the configuration to your
router.
4. The system reboots automatically after a successful file transfer.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on restoring using TFTP (note that you must
remain in the menu to back up using TFTP), please see your router manual.
client program. For details on restoring using TFTP (note that you must
remain in the menu to back up using TFTP), please see your router manual.