ZyXEL Communications 2602H Series User Manual
Prestige 2602H/HW Series User’s Guide
Chapter 26 Menu 3 LAN Setup
307
Follow the instructions in the following table to configure TCP/IP parameters for the Ethernet port.
Size of Client IP Pool
This field specifies the size or count of the IP address pool.
Primary DNS Server
Secondary DNS Server
Secondary DNS Server
Enter the IP addresses of the DNS servers. The DNS servers are passed to
the DHCP clients along with the IP address and the subnet mask.
Remote DHCP Serve
If Relay is selected in the DHCP field above then enter the IP address of the
actual remote DHCP server here.
Table 108 TCP/IP Ethernet Setup
FIELD
DESCRIPTION
TCP/IP Setup
IP Address
Enter the (LAN) IP address of your Prestige in dotted decimal notation
IP Subnet Mask
Your Prestige will automatically calculate the subnet mask based on the IP address
that you assign. Unless you are implementing subnetting, use the subnet mask
computed by the Prestige (refer to the appendix on IP subnetting for more
information).
RIP Direction
Press [
SPACE BAR
] to select the RIP direction. Choices are Both, In Only, Out
Only or None.
Version
Press [
SPACE BAR]
to select the RIP version. Choices are RIP-1, RIP-2B or RIP-
2M.
Multicast
IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to
establish membership in a Multicast group. The Prestige supports both IGMP
version 1 (IGMP-v1) and version 2 (IGMP-v2). Press the [
SPACE BAR]
to enable
IP Multicasting or select None to disable it.
IP Policies
) and apply them
on the Prestige LAN interface here. You can apply up to four IP Policy sets (from
twelve) by entering their numbers separated by commas.
Edit IP Alias
The Prestige supports three logical LAN interfaces via its single physical Ethernet
interface with the Prestige itself as the gateway for each LAN network. Press
[
SPACE BAR
] to change No to Yes and press [
ENTER
] to display Menu 3.2.1.
Table 107 DHCP Ethernet Setup (continued)
FIELD
DESCRIPTION