ZyXEL Communications 2602H Series User Manual

Prestige 2602H/HW Series User’s Guide

338

Chapter 32 Network Address Translation (NAT)

Figure 177   Menu 4 Applying NAT for Internet Access

The following figure shows how you apply NAT to the remote node in menu 11.1. 

1 Enter 11 from the main menu.

2 When menu 11 appears, as shown in the following figure, type the number of the remote 

node that you want to configure.

3 Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes and then 

press [ENTER] to bring up Menu 11.3 - Remote Node Network Layer Options.

Figure 178   Applying NAT in Menus 4 & 11.3

The following table describes the options for Network Address Translation.

Menu 4 - Internet Access Setup
            ISP's Name= MyISP
            Encapsulation= RFC 1483
            Multiplexing= LLC-based
            VPI #= 8
            VCI #= 35
            ATM QoS Type= UBR
              Peak Cell Rate (PCR)= 0
              Sustain Cell Rate (SCR)= 0
              Maximum Burst Size (MBS)= 0
            My Login= N/A
            My Password= N/A
            ENET ENCAP Gateway= N/A
            IP Address Assignment= Static
              IP Address= 0.0.0.0
            Network Address Translation= SUA Only
              Address Mapping Set= N/A

Press ENTER to Confirm or ESC to Cancel:

Menu 11.3 - Remote Node Network Layer Options

IP Options:                          Bridge Options:
  IP Address Assignment = Static       Ethernet Addr Timeout(min)= N/A
  Rem IP Addr = 0.0.0.0
  Rem Subnet Mask= 0.0.0.0
  My WAN Addr= 0.0.0.0
  NAT= SUA Only
    Address Mapping Set= N/A
  Metric= 2
  Private= No
  RIP Direction= Both
    Version= RIP-2B
  Multicast= None
  IP Policies=

Enter here to CONFIRM or ESC to CANCEL: