ZyXEL Communications PLA SERIES User Manual
Chapter 6 Troubleshooting
PLA Series User’s Guide
50
6.3 Powerline Problems
The signal on my powerline network is weak.
1
Your powerline adapters may be connected to electrical surge protectors. Connect them to standard
power outlets.
power outlets.
2
Your powerline adapters may be located close to large appliances such as refrigerators or air-
conditioners that cause interference with the powerline signal. Move the adapters further away
from such appliances to reduce interference.
conditioners that cause interference with the powerline signal. Move the adapters further away
from such appliances to reduce interference.
3
Your powerline adapters may be placed close to electrical devices such as electrical insect-killers
which produce radio waves. These may interfere with the powerline signals. Move the adapters
further away from such electrical devices.
which produce radio waves. These may interfere with the powerline signals. Move the adapters
further away from such electrical devices.
4
Your wiring may be old and/or low quality or with a long wiring path.
6.4 RESET/ENCRYPT Button Problems
This section applies only to PLAs with the RESET/ENCRYPT button.
In this guide RESET/
ENCRYPT refers to the ENCRYPT button in PLAs that have separate RESET and
ENCRYPT buttons.
Refer to
to see which models have separate RESET and
ENCRYPT buttons.
The HomePlug light is already on, but I haven’t pressed the RESET/ENCRYPT button yet.
Your device has already connected to another powerline device. Press the RESET/ENCRYPT
button for 5 to 8 seconds to release the connection.
button for 5 to 8 seconds to release the connection.
The POWER light does not blink when I press the RESET/ENCRYPT button.
• Check the device is on.
• Press the RESET/ENCRYPT button again, making certain you have pressed the button for 0.5 to
• Press the RESET/ENCRYPT button again, making certain you have pressed the button for 0.5 to
3 seconds.
• The POWER light on some powerline devices do not blink as part of the ENCRYPT process. Check
your powerline device is a PLA.
• For PLA, you cannot use the RESET/ENCRYPT button when it is in standby mode. Connect the
PLA to a computer/router then try again.