ZyXEL Communications 240B User Manual

15-4  

Len Comp 

Press [SPACE BAR] and then [ENTER] to choose from Equal, Not Equal, 
Less, Greater, Less or Equal or Greater or Equal. 

Source  

addr start / end  Source IP address range from start to end. 

port start / end  Source port number range from start to end; applicable only for TCP/UDP. 

Destination  

addr start / end  Destination IP address range from start to end. 

port start / end  Destination port number range from start to end; applicable only for TCP/UDP.

Action 

Specifies whether action should be taken on criteria Matched or Not Matched.

Gateway addr 

Defines the outgoing gateway address. The gateway must be on the same 
subnet as the EXPWAVE if it is on the LAN, otherwise, the gateway must be 
the IP address of a remote node. The default gateway is specified as 0.0.0.0. 

Type of Service 

Set the new TOS value of the outgoing packet. Prioritize incoming network 
traffic by choosing No Change, Normal, Min Delay, Max Thruput, Max 
Reliable or Min Cost. 

Precedence 

Set the new outgoing packet precedence value. Values are 0 to 7 or No 
Change. 

Log 

Press [SPACE BAR] and then [ENTER] to select Yes to make an entry in the 
system log when a policy is executed. 

When you have completed this menu, press [ENTER] at the prompt “Press [ENTER] to confirm or [ESC] to 
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen. 

This section shows you where to apply the IP policies after you design them. 

From Menu 3 – Ethernet Setup, type 2 to go to Menu 3.2 – TCP/IP and DHCP Ethernet Setup. 

You can choose up to four IP policy sets (from 12) by typing their numbers separated by commas, for example, 2, 4, 7, 
9. 

Menu 3.2 - TCP/IP and DHCP Ethernet Setup 

 

                    DHCP= Server 

                    Configuration: 

                      Client IP Pool Starting Address= 192.168.1.33 

                      Size of Client IP Pool= 32 

                      Primary DNS Server= 0.0.0.0 
                      Secondary DNS Server= 0.0.0.0 

                      DHCP Server Address= N/A 

 

                    TCP/IP Setup: 

                      IP Address= 192.168.1.1 

                      IP Subnet Mask= 255.255.255.0 
                      RIP Direction= Both 

                        Version= RIP-1 

 

 

                      IP Policies= 2,4,7, 9 

 

                    Press ENTER to Confirm or ESC to Cancel: 
Press Space Bar to Toggle. 

Type IP Policy
sets, 
separated by 
commas.