ZyXEL Communications 10 User Manual
ZyWALL 10
2
Hardware Installation
Rear Panel
LABEL DESCRIPTION
1.
10/100M LAN
Connect a computer to this port with an Ethernet cable. This port is auto-negotiating (can
connect at 10 or 100Mbps). Push the UPLINK button in with a straight-through Ethernet cable or
have the UPLINK button out with a crossover Ethernet cable.
connect at 10 or 100Mbps). Push the UPLINK button in with a straight-through Ethernet cable or
have the UPLINK button out with a crossover Ethernet cable.
2.
10 WAN
Connect your cable/DSL modem to this port with the Ethernet cable that came with your modem.
3.
POWER 12VDC
Connect the included power adaptor (use only this adapter) to this power socket.
After you’ve made the connections, connect the power cable to a power supply and look at the front panel LEDs.
CONSOLE
Only connect this port if you want to configure the ZyWALL using the SMT via console port; see
your User’s Guide for details.
your User’s Guide for details.
Connect the male end of the console cable to the console port of the ZyWALL and the other end
to a serial port (COM1, COM2 or other COM port) on your computer. Your computer should have
a terminal emulation communications program (such as HyperTerminal) set to VT100 terminal
emulation, no parity, 8 data bits, 1 stop bit, no flow control and 9600 bps port speed.
to a serial port (COM1, COM2 or other COM port) on your computer. Your computer should have
a terminal emulation communications program (such as HyperTerminal) set to VT100 terminal
emulation, no parity, 8 data bits, 1 stop bit, no flow control and 9600 bps port speed.