ZyXEL Communications 2R-P1C User Manual

P-2301/2R-P1C / P-2301RL-P1C User’s Guide

26

The ZyXEL Device automatically restarts. When the POWER 
light stops blinking and stays on, follow the directions in 
section 

 on page 

 to log in to the web configurator again. 

However, use the Management IP Address you set up in step 

, instead of 

http://192.168.1.1

. If your computer’s IP address 

is in a different subnet, follow the directions in 

 on page 

 to change your computer’s 

IP address.

Use the following sections to make outgoing calls (from a 
phone attached to the ZyXEL Device, to another phone) and 
incoming calls (from another phone, to a phone connected to 
the ZyXEL Device).

Follow these directions to make calls over the Internet.

• If you want to dial a SIP number that only uses numbers (for 

example, “12345”), dial the number on your phone’s keypad. 
You can also set up a speed-dial entry, if you want, in the 
Phone Book > Speed Dial screen.

• If you want to dial a SIP number that uses letters or if you 

want to make a peer-to-peer call, set up a speed-dial entry 
first. Use the Phone Book > Speed Dial screen. Then, dial 
the speed-dial number to make the call.

• If you want to call a PSTN phone over the Internet, follow 

your VoIP provider’s instructions.