ZyXEL Communications 2 Plus User Manual

 Chapter 34 Remote Node Setup

ZyWALL 2 Plus User’s Guide

The ZyWALL supports PPPoE (Point-to-Point Protocol over Ethernet). You can only use 
PPPoE encapsulation when you’re using the ZyWALL with a DSL modem as the WAN 
device. If you change the Encapsulation to PPPoE, then you will see the next screen.

Server

This field is valid only when RoadRunner is selected in the Service Type field. The 

ZyWALL will find the RoadRunner Server IP automatically if this field is left blank. If 

it does not, then you must enter the authentication server IP address here.

Relogin Every 

(min) 

This field is available when you select Telia Login in the Service Type field.
The Telia server logs the ZyWALL out if the ZyWALL does not log in periodically. 

Type the number of minutes from 1 to 59 (30 recommended) for the ZyWALL to wait 

between logins.

Route

This field refers to the protocol that will be routed by your ZyWALL – IP is the only 

option for the ZyWALL.

Edit IP

This field leads to a “hidden” menu. Press [SPACE BAR] to select Yes and press 

[ENTER] to go to Menu 11.1.2 - Remote Node Network Layer Options.

Session Options

Schedules

You can apply up to four schedule sets here. For more details please refer to 

Edit Filter Sets

This field leads to another “hidden” menu. Use  [SPACE BAR] to select Yes and 

press [ENTER] to open menu 11.x.4 to edit the filter sets. See 

 for more details.

Edit Traffic 

Redirect

Press [SPACE BAR] to select Yes or No. 
Select No (default) if you do not want to configure this feature. Select Yes and press 

[ENTER] to configure Menu 11.1.5 - Traffic Redirect Setup.

Once you have configured this menu, press [ENTER] at the message “Press ENTER to Confirm...” to 

save your configuration, or press [ESC] at any time to cancel.

Table 190   Menu 11.1: Remote Node Profile for Ethernet Encapsulation (continued)