ZyXEL Communications 2002 User Manual

P-2002 Series User’s Guide

Chapter 3 System Screens

37

The Prestige uses the following pre-defined list of NTP time servers if you do not specify a 
time server or it cannot synchronize with the time server you specified.
Note: The Prestige can use this pre-defined list of time servers regardless of the Time 
Protocol you select.
When the Prestige uses the pre-defined list of NTP time servers, it randomly selects one server 
and tries to synchronize with it. If the synchronization fails, then the Prestige goes through the 
rest of the list in order from the first one tried until either it is successful or all the pre-defined 
NTP time servers have been tried.

To change your Prestige’s time and date, click SYSTEM in the navigation panel, then the 
Time Setting tab. The screen appears as shown. Use this screen to configure the Prestige’s 
time based on your local time zone. 

Table 5   Password

Old Password

Type the default password or the existing password you use to access the 

system in this field. Use up to 32 ASCII characters.

New Password

Type the new password in this field.

Retype to Confirm

Type the new password again in this field.

Apply

Click Apply to save your changes back to the Prestige.

Reset

Click Reset to begin configuring this screen afresh.

Table 6   Pre-defined NTP Time Servers

ntp1.cs.wisc.edu

ntp1.gbg.netnod.se

ntp2.cs.wisc.edu

tock.usno.navy.mil

ntp3.cs.wisc.edu

ntp.cs.strath.ac.uk

ntp1.sp.se

time1.stupi.se

tick.stdtime.gov.tw

tock.stdtime.gov.tw

time.stdtime.gov.tw