ZyXEL Communications 35 User Manual

ZyWALL 35 Internet Security Appliance 

 

2 

1 Hardware Connections 

Refer to section 1.3 on how to setup your ZyWALL. 

 

RESET 

You only need to use this button if you’ve forgotten the ZyWALL’s password. It returns 
the ZyWALL to the factory defaults (password is 1234, LAN IP address 192.168.1.1, 
terminal emulation settings as described below etc.; see your User’s Guide for details).  

WAN 10/100 
1/2  

These ports are auto-negotiating (can connect at 10 or 100Mbps) and auto-crossover 
(automatically adjust to straight-through or crossover Ethernet cable). 

LAN/DMZ 
10/100             
1-4 

These ports are auto-negotiating (can connect at 10 or 100Mbps) and auto-crossover 
(automatically adjust to straight-through or crossover Ethernet cable). 

 

DIAL BACKUP 

Only connect this port if you want to set up a backup WAN connection; see your User’s 
Guide for details. 

CONSOLE 

Only connect this port if you want to configure the ZyWALL using the SMT (System 
Management Terminal) via console port; see your User’s Guide for details. 

Your computer should have a terminal emulation communications program (such as 
HyperTerminal) set to VT100 terminal emulation, no parity, 8 data bits, 1 stop bit, no flow 
control and 9600 bps port speed.