ZyXEL Communications 4528F User Manual

Chapter 26 IP Source Guard

XGS-4526/4528F/4728F User’s Guide

Use this screen to look at log messages that were generated by ARP packets and 
that have not been sent to the syslog server yet. To open this screen, click 
Advanced Application > IP Source Guard > ARP Inspection > Log Status.

Figure 125   ARP Inspection Log Status

The following table describes the labels in this screen.

Table 85   ARP Inspection Log Status

Clearing log status 
table

Click Apply to remove all the log messages that were generated 
by ARP packets and that have not been sent to the syslog server 
yet.

Total number of logs

This field displays the number of log messages that were 
generated by ARP packets and that have not been sent to the 
syslog server yet. If one or more log messages are dropped due 
to unavailable buffer, there is an entry called overflow with the 
current number of dropped log messages.

Index

This field displays a sequential number for each log message.

Port

This field displays the source port of the ARP packet.

VID

This field displays the source VLAN ID of the ARP packet.

Sender Mac

This field displays the source MAC address of the ARP packet.

Sender IP

This field displays the source IP address of the ARP packet.

Num Pkts

This field displays the number of ARP packets that were 
consolidated into this log message. The Switch consolidates 
identical log messages generated by ARP packets in the log 
consolidation interval into one log message. You can configure 
this interval in the ARP Inspection Configure screen. See