ZyXEL Communications 4528F User Manual

Chapter 4 The Web Configurator

XGS-4526/4528F/4728F User’s Guide

VLAN Mapping  This link takes you to screens where you can configure VLAN mapping 

settings on the Switch.

Layer 2 
Protocol 
Tunneling 

This link takes you to a screen where you can configure L2PT (Layer 2 
Protocol Tunneling) settings on the Switch.

sFlow

This link takes you to screens where you can configure sFlow settings on 
the Switch.

PPPoE

This link takes you to screens where you can configure how the Switch 
gives a PPPoE termination server additional subscriber information that 
the server can use to identify and authenticate a PPPoE client.

Errdisable 

This link takes you to a screen where you can configure CPU protection 
and error disable recovery.

Private VLAN 

This link takes you to a screen where you can block traffic between ports 
in a VLAN on the Switch.

IP Application
Static Route

This link takes you to a screen where you can configure static routes. A 
static route defines how the Switch should forward traffic by configuring 
the TCP/IP parameters manually.

Policy Routing  This link takes you to screens where you can configure policy routing 

rules.

RIP

This link takes you to a screen where you can configure the RIP (Routing 
Information Protocol) direction and versions. 

OSPF

This link takes you to screens where you can view the OSPF status and 
configure OSPF settings. 

IGMP

This link takes you to a screen where you can configure the IGMP 
settings. 

DVMRP

This link takes you to a screen where you can configure the DVMRP 
(Distance Vector Multicast Routing Protocol) settings. 

DiffServ

This link takes you to screens where you can enable DiffServ, configure 
marking rules and set DSCP-to-IEEE802.1p mappings. 

DHCP

This link takes you to screens where you can configure the DHCP 
settings. 

VRRP

This link takes you to screens where you can configure redundant virtual 
router for your network. 

ARP Learning 

This link takes you to a screen where you can configure ARP learning 
mode on a per-port basis.

Load Sharing 

This link takes you to a screen where you can enable Equal-Cost 
MultiPath (ECMP) routing and set the criteria the Switch uses to 
determine the routing path for a packet.

Management
Maintenance

This link takes you to screens where you can perform firmware and 
configuration file maintenance as well as reboot the system.

Access Control This link takes you to screens where you can change the system login 

password and configure SNMP and remote management. 

Diagnostic

This link takes you to screens where you can view system logs and can 
test port(s).

Table 5   Navigation Panel Links  (continued)